Using the Key Fob
Using the Key Fob
WARNING: The keyless entry system uses low-frequency radio transmissions that might interfere with implanted medical devices. To avoid any possibility of interference, keep such medical devices away from any transmitters.
WARNING: To avoid accidental operation of the vehicle's systems by other occupants, do not leave a key fob in an unattended vehicle.
CAUTION: To ensure your vehicle is left in a secure state, remove all key fobs from the vehicle before leaving it unattended.
Key fob range
The key fob communicates with receivers in the vehicle via Bluetooth® Low Energy and low-frequency radio communication. While it is not necessary to point your key fob at the vehicle, it must be within operating range to work.
Note: The key fob operating range may vary, depending upon environmental factors. Other nearby radio transmitters (e.g., amateur or CB radios, radio or television stations, airports) may interfere with communications between the key fob and the vehicle. Therefore, the ranges listed in this information are approximate. In cases of interference, it may be necessary to move closer to the vehicle than usual in order to operate the key fob.
The key fob can be operated manually once it is detected within 164 ft (50 m) or closer.
All doors automatically unlock and door handles extend if a key fob is detected within 7 ft (2 m).
When leaving your vehicle, all doors automatically lock after all key fobs leave the 20 ft (6 m) radius.
Opening and closing windows with the key fob only works at a distance of 20 ft (6 m) or less from the vehicle.
Key fob operation
Upon coming within 164 ft (50 m) or closer to the vehicle, the key fob should be within range.
Once within range, the key fob operates as follows:
-
If equipped with California Mode, press and hold for two seconds to open all power windows. See California Mode (If Equipped).
-
Press once to unlock all doors.
Press and hold to open all four door windows.
-
Press once to lock all doors.
Press and hold to close all four door windows.
-
Press and hold to fully open or close the liftgate window.
-
Press and hold to open the liftgate.
Key fob troubleshooting
If the key fob does not respond when pressed:
-
Try operating the key fob as closely to your vehicle as possible. Other radio equipment operating on a similar frequency may interfere with the signals from your key fob.
-
The key fob battery may need to be replaced. See Replacing the Key Fob Battery.
If you are still unable to unlock your vehicle with the key fob, contact Fisker via the Fisker App.